Installation manual

Operational procedures
How to store sonar images
Observe the following procedure to store one or more sonar
images.
Prepare the recording parameters
1 Click the Setup tab to open the menu.
2 Click the
Store/Recall button to open the Store/Recall menu.
3 Click the
Store mode button to choose recording mode.
Click the left side of the
Store mode button to scroll down
the list of options. Click the middle of the button to open
the parameter dialogue for direct access to the requested
setting, or click the right side of the button to scroll up the
list of options.
4 Record the images.
5 Click the
Close button to close the Store/Recall menu.
Once the recording has been activated, the sonar will save sonar
images as defined by the
Store mode setting. Each image is added
to the list of temporary files located below the buttons. Each file
name reflects the date and time.
Note that the
Record button on the Operating Panel can be
pressed at any time to start recording. It is not necessary to
open the
Store/Recall menu first. When this button i s used, the
currently selected recording mode will be used.
Record a single image
1 Either:
a Click the
Store button, or
b Press the
Record button on the Operating Panel
2 Observe that the message field below the menu displays the
image file name on a green background.
Record multiple images
1 To start recording:
a Click the
Store button, or
b Press the
Record button on the Operating Panel
2 Observe that the message field below the menu displays the
image file names on a green background.
3 To stop recording:
a Click the
Store button, or
b Press the
Record button on the Operating Panel
164385/E 43