Installation manual

Simrad SH80
Changing a parameter value
Observe this generic procedure t o change a parameter value.
Once you have gained more experience, and have become more
familiar with the available options, you will select the parameters
directly from the buttons.
Figure 8 Changing a parameter value
(C )D015010C
B
C
D
A
1 Move the cursor to the middle of the menu button (A).
Observe that the cursor changes its shape to a menu symbol.
2 Press the
Select button on the Operating Panel.
3 Observe that the corresponding parameter dialogue (B)
opens at the bottom of the menu.
4 Move the cursor down to the dialogue, position the cursor
over the requested parameter value (C), and press the
Select
button again.
5 Observe that the change you have requested takes immediate
effect on the sonar.
• This makes it easy to test the effect of each parameter
setting. Note however that transceiver related parameters
will first be operational in the next ping.
6 Move the cursor down to the
Close button (D), and press
the
Select button again.
7 Observe that the parameter dialogue closes.
Note
In this manual, the phrase “Click the button” means that you
shall position the cursor over the menu button, and then press
the
Select button on the Operating Panel.
Certain parameter settings are identified with an asterisk (*). This
symbol indicates the default setting known to perform well under
normal conditions. If you get “lost“ in the parameter settings, the
28
164385/E