Installation manual

On-board maintenance
Hoist/lower contactors K301 and K302
If the 3-phase voltage for the hoist/lower motor is available, the
transducer can be hoisted and lowered by operating the hoist
(
K301)andlower(K302) contactors in the Motor Control Unit by
activating the small switch handle on the front of the contactor.
Figure 43 Location of K301 and K302
S 302
K301 K302
S 303
REMOTE
HOIST STOP
LOWER
(CD015406C)
K301 K302
WARNING
The switches must be released before the
transducer shaft reaches upper or lower position,
as this operation overrides the two limit switches.
164385/E 191