Installation manual
Simrad SH80
Transducer
The Transducer parameter dialogue opens when you click the
Transducer button in the Status parameter dialogue.
The transducer position is normally selected from the Operating
Panel, and in addition to the LED indicators on the panel, the
transducer position is shown in the
Status parameter dialogue.
The buttons in this parameter dialogue correspond to their
respective buttons on the Operating Panel, and allows you to
control the transducer position by means of the sonar’s menu
system.
Options
Off: Click to switch off the sonar system.
Up: Click to retract the transducer array to its upper position.
Middle: Click to position the transducer array in its middle
position. This position is defined by means of the
Middle Pos
button. Note that the hull unit installed must provide this feature
for this function to work.
Down: Click to lower the transducer array.
Close: Click to close the parameter dialogue.
Help: Click to access the on-line help.
Related topics
Status on page 155
Middle Pos on page 130
162
164385/E