Installation manual

Parameters
Message Bar
The Message Bar parameter dialogue opens when you click the
Message Bar button in the System Test menu. The System Test
menu is in turn opened by clicking the Tes t button on the Setup
menu. (► System Te st menu on page 90) (► Setup menu on
page 84)
The sonar automatically issues messages when a disturbance
occur. The messages are grouped into four categories, and this
parameter dialogue is used to select at which level warnings and
alarms shall be presented. Note that messages are also indicated
in the
Status parameter dialogue. (► Status on page 155)
The Message Bar is located at the bottom of the display. It
contains four buttons, one for each category of m essages. These
buttons give an overview of the number of unread messages
currently in the system, and each of the four buttons gives access
to a menu where each m essage can be read, acknowledged and
deleted. When no messages are present, the four buttons are grey.
When one or more unread messages exists, the
Warning and
Operational Alarm buttons are yellow, while the System Alarm
and Error buttons are red.
Options
Off: Click to switch off the Message Bar. It will not be shown,
even if messages are i ssued.
On Error: Click to allow the Message Bar to appear only when
error m essages are issued by the sonar.
On Sys.Alarms: Click to allow the Message Bar to appear only
when system alarms are issued by the sonar.
On Op.Alarms: Click to allow the Message Bar to appear only
when operational alarms are issued by the sonar.
On Warning: Click to allow the Message Bar to appear only when
warnings are issued by the sonar.
Always On: Click to switch the Message Bar permanently on.
Close: Click to close the parameter dialogue.
Help: Click to access the on-line help.
164385/E 129