Installation manual

Simrad SH80

External Synchronisation

The External Synchronisation parameter dialogue opens when

you click the

External Sync buttonontheSetup menu.

This function makes it possible to eliminate interference from

other Simrad sonars on board the vessel. If the sonars are

connected together, you can use these settings to synchronise

their transmissions.

Options

Sync mode: Click to select one of the three synchronization

modes below.

Mode

None: Click to disconnect the SH80 from the

synchronisation system. The sonar will then operate completely

on its own.

Mode

Slave: Click to connect the S H80 as a slave to an external

system. The external system will then instruct the sonar when

to transmit.

Mode

Master: Click to allow the SH80 to be in control. The sonar

will then instruct the external system on when it can transmit.

Delay: Click to select the delay between the SH80 transmission

and the transmission of the external system, or vice versa. A

dedicated dialogue is provided to make the selection.

Close: Click to close the parameter dialogue.

Help: Click to access the on-line help.