Installation manual

Parameters

Bearing (Vertical)

The Bearing (Vertical) parameter dialogue opens when you click

the

Bearing buttonintheVertical menu.

This dialogue allows you to train the audio channel bearing

manually. The bearing of the audio channel is normally

controlled with the

Train buttons on the Operating Panel. The

bearing of the vertical slice, which is presented by the white

audio line in the horizontal picture, may also be trained by the

Bearing button in the Horizontal menu.

The following options are available in the

Bearing (Vertical)

parameter dialogue:

• + (plus): Allows you to increase the bearing angle.

• – (minus): Allows you to decrease the bearing angle.

•

Close: C lick to close the parameter dialogue.

•

Help: Click to access the on-line help.

More information about the train control is provided in the

Operating Panel chapter.