Installation manual

Simrad SH80
IV
851-164300 / C
2 INSTALLATION PLANNING 23.............................
2.1 General 23.................................................
2.2 Location of the Hull Unit 24...................................
Fore and aft 24.............................................
Athwartships 24............................................
Important considerations 24...................................
2.3 Sonar room requirements 26...................................
Size 26...................................................
Access hatches 26...........................................
Lifting 26.................................................
Heating 26................................................
Insulation 26...............................................
Ventilation 26..............................................
Conduit 27................................................
Bilge pump 27.............................................
Lighting 27................................................
Dry docking 27.............................................
Decking 27................................................
3SONARTRUNK 30...........................................
3.1 Mounting of t he trunk 30......................................
3.2 Protection 31...............................................
Protecting blister 31.........................................
Corrosion protection 31......................................
3.3 Trunk installation measurements 31.............................
3.4 Principles 32................................................
4HULLUNIT 35...............................................
4.1 Introduction 35..............................................
4.2 Unpacking 36...............................................
4.3 Mounting 38................................................
4.4 Mechanical support 39........................................
4.5 Transducer alignment 40......................................
4.6 Installation check--list 41......................................
5 TRANSCEIVER UNIT 42.....................................
Introduction 42.............................................
Procedure 42...............................................
6 WHEELHOUSE UNITS 46....................................
6.1 Overview 46................................................
6.2 Location 47................................................