Installation manual

Cable layout and connections

851--164300 / C

1 Run the 100 m data cable from the wheelhouse and down to

the sonar room.

Note The data cable from the wheelhouse to the sonar room must be

supported and protected along its entire length using conduit

and/or cable trays. The cable must not be installed in close

proximity to high-power cables antenna cables or other possible

sources of interference.

This cable must not be spliced. If it is not long enough, or if an

accident occurs with it, contact your local dealer or Simrad for

advice.

2 Locate the RJ-45 connector (included with the delivery), and

mount the connector J5 as shown on the cable connection

drawing.

3 Do not connect the plug to the Sonar Interface Unit.

→ Cable details on page 161

→ The installation of this cable into the Transceiver Unit is

described later. See page 66.