Installation manual

Simrad SH80

851--164300 / C

7.4 Wheelhouse cabling

Introduction

Connections to the Sonar Processor Unit are made on the

connectors on the rear side of the unit. The fixed connectors are

specified on the identification panel, while the circuit board

connectors are identified with Jx tags.

Note The Sonar Processor Unit provides a large number of connectors

that are not used by the SH80 sonar.

Connections to the Sonar Interface Unit are made on the terminal

blocks and connectors on the main circuit board. To access to

connectors, open the unit’s lid. An identification panel is available

inside the Sonar Interface Unit.

For connection of the peripheral equipment, refer to section

Peripheral equipment.

→ Refer to page 73.