Installation manual

Simrad SH80

851--164300 / C

6.4 Sonar Operating Panel

Observe the following procedure. To ensure correct operation, tick

off every item when the action has been carried out.

1 Mount the Sonar Operating Panel in an almost horizontal

position to facilitate operation of the trackball.

- The necessary mounting hardware (four screws, four nut

plates and four bolt covers) are supplied in the standard

delivery.

2 Drill and cut the panel opening as shown in the figure.

3 Mount the Sonar Operating Panel using the supplied

hardware.

a Position the four nut plates shown in the figure.

b Use a 3 mm Allen key to fasten the four special bolts.

c Mount the bolt covers in the four corners of the Operating

Panel.

372 mm

Nut plate

152 mm

ø7x4

(CD5654)

Figure 15

Operating panel

cut-out