Installation manual

Simrad SH80
22
851--164300 / C
Caution If, for any reason, it is necessary to move the circuit board or
components from the conductive service mat, they must be
placed in an approved anti-static transportation container (e.g.
static shielding bag) before transportation.
• During installation and servicing, all electrical equipment
(soldering irons, test equipment etc.) must be earthed.
Temperature protection
If the unit must be protected against extremes of temperature, the
carton/crate must be lined on all walls, base and lid with 5 cm thick
polyurethane or polystyrene foam.
These units will be identified as delicate in the applicable
documentation.
The package must then be clearly marked:
Must not be transported or stored in temperatures
below -5 degrees Celsius.
Other units can normally be stored in temperatures between -30°C
and +70°C, though refer to the system’s Technical Specifications
document for details.
Transducers must not be stored in temperatures below -20°C.