Installation manual

Simrad SH80
14
851--164300 / C
Heavy units may be equipped with lifting lugs for transportation
by crane within the workshop or installation area. Before a crane
is used, check:
• The applicable weight certificate for the crane.
• The security of the lifting lugs.
Ensure that all available lifting lugs are used. Ensure the unit
remains under control during the operation to avoid damage to t he
unit, equipment or personnel.
Heavy units may be transported using a fork-lift truck. Special
attention must t hen be paid to the position of the unit’s centre of
gravity. The units must be properly secured to the truck.
Initial preservation
Introduction
When a system, a unit or a spare part has been delivered to the
customer, i t may be subject to long-time storage prior to
installation and use. During this storage period, certain
specifications must be met.
The equipment must be preserved and stored in such a way that it
does not constitute any danger to health, environment or personal
injury.
Specific specifications are presented below.
→ For further information about storage, refer to page 18.
→ For further information about re-packing, refer to page 20.
→ For further information about temperature protection, refer to
page 22.
Original packing crate
1 The equipment must be stored in its original transportation
crate.
2 Ensure that the units are clearly separated in the shelves and
that each unit is easily identifiable.
3 The crate must not be used for any purpose for which it was
not intended (eg. work platform etc.).
4 The crates must not be placed on top of each other, unless
specific markings permit this.
5 The crates must not be placed directly on a dirt floor.
6 Do not open the crate for inspection unless special
circumstances permit so.