Installation manual

Introduction
7
851--164300 / C
1.4 Peripheral equipment
Required inputs
The Simrad SH80 sonar system requires input from both a speed
log and a course gyro. Inaccurate data from either of these
instruments will result in an incorrect indication of vessel and
target movement.
Speed log
The speed log parameters are:
• Pulse log: 200 pulses / nm.
• Serial line, standard NMEA 0183, RS-232
→ Also refer to (D)GPS below.
Course gyro
The course gyro parameters are:
• Serial line, standard NMEA 0183, RS-232
An optional gyro interface box for converting the following
synchro and stepping gyro signals can be ordered from Simrad:
• 3-phase synchro signal, 20 to 150 V L-L, 50/60/400 Hz, gear
ration 1:360 or 1:180
• 3-phase stepper signal, 20 to 150 V L-L, gear ration 1:360 or
1:180
→ Refer to page 5 for the Simrad order number.
Additional inputs
In addition t o the pulse log input described above, the SH80 sonar
provides a total of seven RS-232 serial lines. Since one is used to
interface the course gyro, the remaining six serial lines may be
used for:
• Differential Global Positioning System - (D)GPS
• Echo sounder
• Purse seine system
• Trawl system
• Current meter system
• Radio buoy system
Differential Global Positioning System - (D)GPS
A (D)GPS may be interfaced with the Simrad SH80 sonar to
establish the vessel’s position and provide cursor and marker
latitude and longitude.