Installation manual

Simrad SH80
128
851--164300 / C
10.5 (D)GPS
Observe the following procedure to test the GPS input:
1 Access the I/O Setup menu.
→ A procedure for this is located on page 121.
2 Select Sensors in the I/O Setup menu, then Pos.System,
and f inally GPS.
3 Observe the Sensor Config submenu appears at the bottom
of the menu field.
4 Check that the settings in the Sensor Config submenu
corresponds to your requirements for the serial line.
5 Press Close to exit the Sensor Config menu.
6 Check that the Lat/Long readout in the Status menu
corresponds to the GPS readout.