Installation manual

Simrad SH80
96
851--164300 / C
Display set-up
Observe the following procedure to set up the display and retrieve
simulated sonar echoes.
1 Refer to the instruction manual for the display unit, and
adjust the picture size so the grey picture frame is shown in
the outmost part of the display frame.
2 Use the trackball and the Select button on the Operating
Panel, and observe this procedure to obtain a simulated echo
on the screen.
a Move the cursor to the Setup tab on the right-hand side
of the main menu, and press the Select button.
-TheSetup menu will be displayed.
b Move the cursor t o the Test... buttonintheSetup menu,
and press Select.
-TheSystem test menu will now appear in the menu
field.
c Move the cursor to the Installation Menu button and
press Select.
-TheInstallation menu will now appear on the top of
the screen.
d Move the cursor to Simulation and press the Select
button. Select Modes and then Auto.
3 Check that simulated echoes are displayed on the screen after
a few seconds.
- If not, check that the tilt angle in the upper left-hand
corner is set to 0 degrees.