Installation manual
Simrad SH80
88
851--164300 / C
- Write down the measured voltage here:
Supply voltage (Vac):
5 Check that the measured voltage corresponds to the voltage
(115 Vac or 230 Vac) marked on the label of the Transceiver
Unit’s front door.
6 Reinsert the mains input connector P201 on the f ront of the
power supply.
7 Check that lamps L203 and L204 on the front of the power
supply illuminate.
8 Check that the small LED (Light Emitting Diode) for the
+24 Vdc stand-by power on the Power Control Unit
illuminates.
The +24 Vdc stand-by power is now supplied both to the Hull Unit
and to the connector for the Sonar Interface Unit.