Installation manual

Simrad SH80
VI
851-164300 / C
9.2 Check--list before start--up commences 86.........................
9.3 Starting up the stand--by power supply 87.........................
9.4 Starting up the Hull Unit 89....................................
Introduction 89.............................................
Functional check 89.........................................
Apply 3-phase AC power 92..................................
Re-wire for 230 Vac 3-phase 92................................
Functional check with power 92...............................
9.5 Starting up the Wheelhouse Units 95.............................
Introduction 95.............................................
Start up 95................................................
Display set-up 96...........................................
9.6 Checking the Operating Panel 97...............................
Introduction 97.............................................
Functional test 97...........................................
Power off 101...............................................
9.7 Checking the hoisting/lower system 102...........................
Introduction 102.............................................
Preparations 102.............................................
Checking the bridge functions 103..............................
Checking the sonar room functions 107..........................
9.8 Starting up the Transceiver Unit 108..............................
9.9 Self-- noise test 110............................................
9.10 System start--up 111...........................................
Introduction 111.............................................
Preparations 111.............................................
Starting up the transmitter 112..................................
Actions on the bridge 113.....................................
Actions in the sonar room 115..................................
9.11 Alignment of the sonar picture 116...............................
9.12 Setting own ship parameters 118.................................
Ship dimensions 118.........................................
Instrument position offsets 118.................................
10 TESTING THE PERIPHERAL EQUIPMENT 120...............
10.1 Introduction 120..............................................
10.2 General 121.................................................
Default interface settings 121...................................
Changing the interface settings 121..............................
Serial line inspection 122......................................