Installation manual

Simrad SD570
20
850--160139 / A
If the operator wishes to change one of the settings in the menu,
the cursor must be moved up or down until it covers the desired
function. Press ENTER, and the submenu for this controlfunction
will appear on the screen. The cursor will then be on the relevant
setting.
Move the cursor to the desired function and press ENTER to
complete the operation. The submenu will disappear, and the
new setting will now appear in the main menu.
Note that the cursor will stop in upper or lower position in the
menu field when the joystick is kept in up or down position.
When a new operation of the joystick is then made in the same
direction, the menu cursor will jump to the opposite end of the
menu.
This chapter describes all submenus of the main menu, the extra
menu and the catch data pages. For an explanation of how to use
the menu system, refer to chapter 2.