Installation manual

Introduction

851--160117 / B

Figure 8 - The main control panel

j Press the GEAR button (3, button no. 4) and check if a

seine circle appears beside the ship symbol, and that the

button lights up. A second press should give a yellow

square at the ship symbol, and a third press should

remove the seine circle and extinguish the button light.

j Select MODE True Motion in the menu, and press the

DISPLAY CENTRE button (3, button no. 5) to check if a

new centre is formed.

j Press the GAIN +/-- buttons (4 lower) and check if the

readout in theupperright--hand corner ofthescreencan

be changed from 0 to 50.

j PresstheRANGE+/--buttons(5)andcheckifthereadout

in the upper right--hand corner of the screen can be

changedtothefollowingranges:125,250,375,750,1000,

1500, 2000, 3000 and 4000 m.

j PresstheTILTUP/DOWNbuttons(7)tocheckthetilting

onthetiltindicator.AlsopresstheAUTObuttontocheck

if the button lights up, and that the tilt limits appear on

the tilt indicator. Then press the MAN button to stop the

automatic tilting.

j Press the PANEL ILLUMINATION +/-- buttons (8) to

check the adjustment of the backlight and signal light in

the push buttons.

j Use the MANUAL TRAIN buttons (9 right) to check the

training of the white audio line on the screen. Try both

directions.

j Press the AUTO SEARCH button (9) and check that the

sector limits are displayed.