Installation manual

Introduction
37
851--160116 / B
Figure 21 - Connections for a gyro with
serial line output
j Disconnect the two display cable plugs on the drawer
unit, and dismount the top cover of the drawer.
j Locate the DIL switch S2 (refer to figure 19), and set the
switches according to the table on next page.
G
Y
R
O
DIL SWITCH S2
G
Y
R
O
1 2 3 4 5 6 7 8
SERIAL LINE OUTPUT OFF OFF OFF OFF OFF ON OFF OFF
Locate the links LK2, LK3 and LK6 on the Control Unit Board,
(see figure 19) and set the links according to the table below.
GYRO LINK SETTING
LK2 LK3 LK6
RS232 OUT IN OUT
RS422 OUT OUT IN
20 mA current loop IN OUT OUT
Do not insert the Control Unit drawer until mentioned in a later
chapter.