Installation manual

Introduction

851--160116 / B

Figure 15 - Termination of the cable main screen

j Continue with cable no. 4 through the cable gland on the

righthandside (see figure14)andmake the termination

of the main screen according to figure 15. Make the

connections to terminal E201 according to the

interconnection diagram.

Note that the mains power connection to the Transceiver Unit can

be 115 VAC or 230 VAC. Use the following procedure for the

connection of the mains power:

j Pull out the mains input connector P201 on the power

supply in the Transceiver Unit. For location of the

connector, refer to figure 16.

j Set the mains voltage selector switch S201 on the Power

Supply and S203 on the HV Power Unit to correspond to

thecorrectmainsvoltage(115Vor230V),andreplacethe

switch lock to secure the switch in the correct position.

j Set the service switch S202 on the Power Supply to OFF

(middle) position.