Installation manual

Simrad SD570 / Base version
18
851--160116 / B
Panel mounting
j Dismount the mounting bracket from the Sonar Control
Unit by unscrewing the four bolts on the front. An Allen
key is located in the spare parts box.
j Cut the panel opening to the following size:
Width: 345 mm
Height: 380 mm
j Place the cabinet into the opening to mark the four
fastening holes.
j Remove the cabinet and drill the four fastening holes in
the panel.
Metal panel: Drill 5mm holes for threading with M6 tap, or
7mm holes if through-bolts with nuts are preferred.
Wooden panel: Drill 9mm holes for the four thread inserts
which are located in the spare parts box. Refer to figure 11 for
information about mounting the thread inserts.
Figure 11 - Mounting the thread inserts
j Place the cabinet into the opening and fasten it with the
four bolts.
Bulkhead mounting
To obtain the best operation position of the cabinet, the cabinet
should be mounted with a tilt angle of approximately 20 . An
optional mounting bracket can be delivered from Simrad.
j Dismount the mounting bracket from the Sonar Control
Unit by unscrewing the four bolts on the front. An Allen
key is located in the spare parts box.