Installation manual

Simrad SD570 / Base version
12
851--160503 / B
4 MOUNTING THE ADAPTER FLANGE
If the adapter flange is delivered from Simrad, the gasket to be
used between the old trunk and the adapter flange is located in a
plastic bag under the blind cover.
When mounting the adapter flange, tighten the flange nuts with
a torque of approximately 6 kpm.
For installation of the Hull Unit, refer to chapter 3 in section
”Installation Procedures”.
Caution ! If thevessel hasto be launched without mounting the Hull Unit,
remember to tighten up the blind cover nuts with a torque of
approximately 6 kpm.