Installation manual

Simrad SD570 / Base version
8
851--160503 / B
3.2 SQ and SB2 adapter flange
Figure 6 shows the SQ and SB2 trunk with the adapter flange for
mounting the SD 570 / SE 570 Hull Unit. This adapter flange may
be made bythe shipyard,or be delivered from Simrad as an option
(Simrad reg. no. SD5-112642). The optional adapter flange which
is approved by Det Norske Veritas (DnV), also includes a blind
cover and a gasket set.
The drawings of the adapter flange and blind cover are included
in section ”Drawings”:
- SQ/SB2 adapter flange: drawing no. 830-113236. . . . . . .
- Blind cover: drawing no. 830-113233. . . . . . . . . . . . . . . . . .
Figure 6 shows the SQ / SB2 trunk with the adapter flange
mounted. For future use, the measurements of the distance A, and
the heights B and C shown in figure 6 have to be carried out and
put into the tables below.
Distance A:
mm: inches:
Height B:
mm: inches:
Height C
mm: inches:
The complete height of the trunk and adapter flange C must be
minimum 920 mm (36 1/4“).
For mounting the adapter flange, refer to chapter 4.