Installation manual

Simrad SD570 / Base version
2
851--160503 / B
2 DIFFERENT TRUNK SYSTEMS
The figures in the following chapters show the top flange for the
different trunks which can be used for installing the SD 570 / SE
570 Hull Unit. If a trunk is already installed, use these figures to
find the type of trunk. This also to find if an adapter flange is
needed, and in such a case, which type.
2.1 The SX and SL trunk
Figure 1 shows the top flange for the SX and SL trunk.
Figure 1 - The top flange for the the SX/SL trunk
The SX and SL trunks are the same type which are used for a
normal installation of the SD 570 / SE 570 Hull Unit, and therefore
no adapter flange is needed.
To check the minimum height of the trunk, refer to the figures 4
and 5 in section ”Installation procedures”.