Installation manual

Introduction
35
851--160117 / B
7.5 Remounting the electronic drawer unit
When both the course gyro and speed log work properly, the
electronic drawer unit can be installed into the cabinet:
j Set the switch S101 at the rear of the drawer to OFF.
j If the external cable connections not are threaded
throughthecabinet,disconnectalltheconnectionsatthe
rear of the drawer unit.
j Disconnect the two cables from the drawer unit to the
display.
j Remount the drawer cover.
Figure 13 - Remounting the electronic drawer unit
j Arrangethetwo displaycablesasshownin figure13and
guide the drawer unit gently into the cabinet. Be aware
ofthe twoguidingpinsattherearofthecabinettomatch
the holes at the rear of the drawer unit. Fasten the
drawer unit with the four front fastening screws.