Installation manual

Simrad SD570 / Base version
28
851--160117 / B
* Check that the voltmeter on the HV power unit shows
approx. 40 volt.
j SettheTXPOWERinthemainmenutoFULL,andcheck
that the echoes become still stronger.
* Check that the voltmeter on the HV power unit shows
approx. 90 volt.
Note that if the Hull Unit is installed differently from the
recommended orientation shown in figure 6 in section
“Installation procedures”, the echo picture on the display has to
be aligned to show the echoes in correct position (see the
procedure in chapter 6.4).