Installation manual

Simrad SD570 / Base version

851--160117 / B

j Press the HOIST button, and check if the text

HOISTING: UPPER is shown in the menu. Also check

thatboth buttonslightduringthehoisting,and thatonly

theHOISTbuttonlightswhenthetransducerstopsinthe

fully hoisted position. The menu should now show the

text TRANSD. POS: UPPER.

j Press the LOWER button for approximately 2 seconds,

and check if the text LOWERING: LOWER is shown in

the menu. Also check that both buttons light during the

lowering, and that only the LOWER button lights when

the transducer stops in the fully lowered position. The

menushouldnowshowthetextTRANSD.POS:LOWER.

j PresstheHOISTbuttonforapproximately2seconds,and

check if the text HOISTING: UPPER is shown in the

menu. Also check that both buttons light during the

hoisting,andthatonlytheHOISTbuttonlightswhenthe

transducer stops in the fully hoisted position. The menu

should now show the text TRANSD. POS: UPPER.

* SettheswitchinthemotorcontrolunittoSTOPposition.

j Switch OFF the Sonar Control Unit by pressing the

ON/OFF--HOIST button for approximately 2 seconds.