User's Manual Part 2

RS81/RS82 VHF
90
E04572
NOTE The call will be terminated, if it is not accepted within 15
seconds.
When calling an intercom speaker, use the V
OL ▲ and VOL ▼
keys while the PTT key is held to adjust the intercom speaker
volume. This option is not available when calling another sta-
tion or making an all speaker / PA call – the current volume
settings for each position will be used.
To end the intercom call, press O
N/C or return the handset to
its cradle.
NOTE While making an intercom call, all other stations will display
“STATION X OCCUPIED”.
NOTE If the interrupt intercom option (section 8.3.4) is disabled and a
VHF transmission is being received, the display will show
“SIGNAL PRESENT” until the transmission has ended. If inter-
com interruption is enabled, the intercom call will be interrupt-
ed if a VHF transmission is received.
11.7.2 Receiving an intercom call
If an intercom call is received from another station, the display
will show “INTERCOM FROM STN Y”, where “Y” is the ID of
the station making the intercom call (Fig 11.8). To end an inter-
com call, press O
N/C or return the handset to its cradle.
12
I N T ERCOMAA
FROM STN 22
INT
Fig 11.8 - Receiving an intercom call from Station 2
11.8 Station speaker mute
For complete silence at an operating position, the station
speaker (including the handset speaker) may be muted. To
mute the speaker, press S
HIFT followed by 7 (SPEAKER) on the
specific handset that is used with the speaker.
To disable mute, press S
HIFT followed by 7 (SPEAKER) again,
use the V
OL ▲ and VOL ▼ keys, or lift the handset from the cra-
dle. If the system is powered down, the volume settings will be
restored the next time the system is turned on.