Operation Manual
4 RS25 Operation and Installation Manual
ABOUT THIS MANUAL:
1. Some features described in this manual are not available on every model.
2. This manual is based on the RS25.
3. DSC functions will not operate on this radio until a valid user MMSI has been entered and stored.
See Appendix- D for details.
4. The radio channels installed into the radio may vary from country to country, depending upon
the model and government or national communications authority regulations.
5. NAVICO recommends that you check the radio operating licensing requirements of your country
before using the radio. The operator is solely responsible for observing proper radio installation
and usage practices.
6. A DSC warning label is supplied with the RS25 US model. To comply with FCC regulations, this
label must be axed in a location that is clearly visible from the operating controls of this radio.
Make sure that the chosen location is clean and dry before applying this label.
RF Emissions Notice:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This device’s antenna must be installed in accordance with provided instructions; and it must be operated
with minimum 96 cm spacing between the antennas and all person’s body (excluding extremities of
hands, wrist and feet) during operation. Further, this transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
Industry Canada
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation
of the device.
Optional Handset
This manual describes the operation and installation procedures for the Simrad RS25U and RS25E base
unit and microphone. An optional Simrad AHK05U or AHK05E handset can be purchased and installed
to provide second station operation and intercom facilities.
Section 7 - Install the RS25 .....................................................................................................................56
7-1 Installation Options ..............................................................56
7-2 Location Requirements ..........................................................56
7-3 Checklist ........................................................................57
7-4 Gimbal Installation ..............................................................58
7-5 Change the Viewing Angle ......................................................58
7-6 Recessed Installation ............................................................58
7-7 Install the Microphone Bulkhead Mount .........................................59
7-8 Connect the Radio Cables .......................................................60
7-9 Set Up the Radio .................................................................60
7-11 The Completed Installation (with Optional AHK05 Handset) .....................62