Installation manual

Simrad PI54
36
851-165187 / Rev.A
Cable gland installation for steel hulls
This cable gland kit is designed for steel vessels. It must be
welded to the hull plates.
(A) = Steel conduit
(B) = Stuffing tube, DNV
approved carbon steel st52.3
(C) = Washers, 24 x 8 x 2 mm
(D) = Rubber gasket
(E) = Packing nipple. Make
sure that you do not damage the
transducer cable by tightening
the packing nipple too hard!
(F) = Cable to the echo
sounder (or a junction box)
The gland gland kit includes all
of the necessary parts needed to
install the unit excluding
screws.
Simrad recommends that a one
inch steel conduit (that the
transducer cable will be run
through) with an inside
threaded diameter of
three-quarter inches is welded
to the gland’s stuffing tube. The
conduit must extend to above
the vessel’s water line.