Installation manual

Transducer installation
25
851-165187 / Rev.A
Wood or polyester hull
A fairing (A), made by the shipyard, is placed between the
transducer and the hull. It is required in order to adapt for the
deadrise angle of the hull, and will also house a cable service
loop (B). The fairing is made from wood, polyester or steel, and
should have the same outline dimensions as the transducer. Use
tarred felt (H) between th fairing and the hull. Remember to
create an air outlet (E) on the fairing, and to fill the bolt holes
with a filling compound to ensure a smooth transducer surface.
(A) = Fairing (1) = Steel conduit
(B) = Cable service loop (2) = Stuffing t ube
(C) = Filling compound (3) = Washer
(D) = 1 -2 degrees inclination (4) = Rubber gasket
(E) = Air outlet (5) = Packing nipple
(F) = Forward
(G) = Shim (wood)
(H) = Tarred felt
(I) = Threaded rod with nuts and washers