Installation manual

Introduction
13
851-165187 / Rev.A
Once unpacked, the equipment must be kept in a dry, non
condensing atmosphere, free from corrosive agents and isolated
from sources of vibration.
Note: Do not break t he seal to open a circuit board package before the
board is t o be used. If the board package is returned to the
manufacturers with the seal broken, the contents will be
assumed to have been used and the customer will be billed
accordingly.
The unit must be installed in its intended operating position as
soon as possible after unpacking.
If the unit contains normal batteries, these may have been
disconnected/isolated before the unit was packed. These must
then be reconnected during the installation procedure. Units
containing batteries are marked.
Caution: Units containing lithium or alkaline batteries must be
handled separately and with care. Such units are
marked accordingly. Do not attempt to recharge such
batteries, open them or dispose of them by
incineration. Refer to the applicable product data
sheets.
After use storage
If a unit is removed from its operating location and placed into
storage, it must be properly cleaned and prepared before
packing.
Cleaning cabinets
If a cabinet has been exposed to salt atmosphere while it was in
use, it must be thoroughly cleaned both internally and externally
to prevent corrosion.
• Wipe the cabinet externally using a damp cloth and a little
detergent. Do not use excessive amounts of water as the unit
may not be water tight. On completion, dry the unit
thoroughly.
• All surfaces must be inspected for signs of corrosion, eg.
flaking/bubbling paint, stains etc. Damaged or suspect areas
must be cleaned, prepared and preserved using the correct
preservation mediums for the unit. The mediums to be used
will usually be defined in the units’ maintenance manual.