Installation manual

Simrad PI54
12
851-165187 / Rev.A
Note: Do not break t he seal to open a circuit board package before the
board is t o be used. If the board package is returned to the
manufacturers with the seal broken, the contents will be
assumed to have been used and the customer will be billed
accordingly.
Assuming all is well, open the bag and remove the unit.
Open the unit and check inside. Remove any packing and
desiccant material that may be inside.
Unpacking mechanical units
Mechanical units may be heavy. Using a suitably certified lifting
apparatus, lift the unit out of the crate and place it in a stable
position on t he floor/work bench.
Inspect the unit for damage and remove any packing material
that may be inside the unit.
Unpacking transducers
Transducers may be supplied m ounted to a hull unit (if any), or
packed separately. Crates are normally identified by the order
number and the serial number.
The transducer face must be protected by a rigid, padded cover
(e.g. a wooden box lined with foam rubber) all the time it is
exposed to the risk of physical damage.
Note: Once the units are unpacked, great care must be taken to ensure
that transducers and cabling are not exposed to any mechanical
stress.
Re-packaging
If the unit is not to be installed immediately, re -pack it in its
original packing material to prevent damage in the intervening
period.
→ Refer to the information on page 15.
Pre-installation storage
The equipment should be stored in its original transportation
crate until ready for installation. The crate must not be used for
any purpose for which it was not intended (eg. work platform
etc.).