Installation manual

Introduction

851-165187 / Rev.A

• Place the carton on a stable work bench or on the floor with

the top of the carton uppermost.

• In the absence of other instructions, always open the top of

the carton first. The contents will normally have been

lowered into the carton from above, so this will usually be

the easiest route to follow.

- Care m ust be used when opening the carton to ensure the

contents are not damaged.

Caution: Do not use a knife to open cardboard cartons - the

contents may lie close to the surface, and may be

damaged by the blade.

• If the carton has been closed using staples, remove the staples

from the carton as you open it. This will reduce the

possibilities of scratch injury to yourself and damage to the

contents.

• If a wooden crate has been closed using screws, always

remove them using a screw-driver. Do not attempt t o prise

the lid off with a crow-bar or similar.

• Once the carton i s open, carefully remove all loose packing

and insulation material. Check for manuals and other

documents that may have been added to the carton during

packing, and put these to one side. Check also for special

tools, door keys etc.

Unpacking electronic and electro-mechanical

units

Caution: Beware of the dangers of Electro-Static Discharge

(ESD) both to yourself and to the equipment, when

handling electronic units and components. Refer to the

precautions starting on page 16.

Electronic and electro-mechanical units will normally be

wrapped in a clear plastic bag. Lift the unit, in its bag, out of the

carton and place it in a stable position on the floor/work bench.

Inspect the unit for damage before opening the plastic bag.

Note: Cables must never be used as carrying handles or lifting points.