Installation manual

Simrad PI54

851-165187 / Rev.A

Caution: Units containing lithium or alkaline batteries must be

handled separately and with care. Such units are

marked accordingly. Do not attempt to recharge such

batteries, open them or dispose of them by

incineration. Refer to the applicable product data

sheets.

Inspection and unpacking

An inspection m ust be carried out immediately after the unit(s)

have arrived at their destination.

• Check all wooden or cardboard boxes, plastic bags and

pallets for physical damage. Look for signs of dropping,

immersion in water or other mishandling.

• If damage is detected externally, you will have to open the

packaging to check the contents.

- Request a r epresentative of t he carrier to be present while

the carton is opened, so any transportation damage can be

identified.

• If any units are damaged, prepare an inspection report stating

the condition of the unit and actions taken. Describe the

damage and collect photographic evidence if possible. Send

the inspection report to Simrad as soon as possible.

• If the units are not damaged, check the humidity absorbing

material. If required, dry or replace the bags, then repack the

unit(s) according to the packing instructions.

Inspection and unpacking: General procedure

Normal precautions for the handling, transportation and storage

of fragile electronic equipment must be undertaken.

Note: If the unit is not to be prepared for immediate use, you may

consider storing it unopened in its original packing material.

However, it may be useful to open the case to check its contents

for damage and retrieve any accompanying documentation.

• Check the carton before opening it to ensure it shows no

signs of dropping, immersion in water or other mishandling.

- If the carton shows signs of such damage, refer to the

paragraph covering Inspection on receipt.