Installation manual

Setup
167
851-165187 / Rev.A
Echo sounder transducers
Observe the following procedure to set up the echo sounder
transducer(s).
1 Power up the PI54.
2 Once up and running, press the MENU button to open the
main menu.
3 Press 4 to open the Setup menu, and STND to open the
Echosounder setup dialogue.
Before you proceed, you must know what kind of echo sounder
transducer(s) you have installed.
The PI54 can be used with maximum two transducers
simultanously, one low frequency (38 or 50 kHz) and one high
frequency (200 kHz). We recommend that any one of the
following transducers are used:
• Simrad 38-200 Combi C (dual frequency)
• Simrad 38-200 Combi D (dual frequency)
• Simrad 38-200 Combi W (dual frequency, wide beam)
Other transducers may also be used. Budget transducers
designed for leasure crafts are however not recommended for
professional fishery applications.
Simrad 38/200 Combi C
Connect the transducer as described in the wiring diagram.
→ Simrad 38/200 Combi C (W814C), page 156
1 In the Echosunder setup dialogue, use the circular
selector pad to move the cursor (inverse video) to the
Transducer 1 / Type location.
2 Press the + button repeatedly until the setting reads
Simrad Combi 38&200.
3 Press the ENT key to save the setting and exit.
You can easily return to this setup page later, but DO NOT alter
the transducer setting unless you replace the transducer.