Installation manual

Sensors
141
851-165187 / Rev.A
The t wo groups must be configured as follows:
Configuration Spread sensor Remote sensors
PI Twin Spread 1 PI Twin Spread (*) Remote 1 Remote 3
PI Twin Spread 2 PI Twin Spread (*) Remote 2 Remote 4
(*) = The same PI Twin Spread sensor is used for both configurations.
By default, it is programmed for PI Twin Spread 1. If you wish to use it
for PI Twin Spread 2, you must re-- configure it using the PI Configura-
tor application.
You can select the communication channels between the PI
Twin Spread sensors and the vessel to suit your preferences.