Installation manual

Simrad PI54
128
851-165187 / Rev.A
Installation choices
The PI54 Operator Unit can be installed as follows:
• Table
• Bulkhead
• Deckhead
• Panel/console
Table
Secure the mounting bracket with
four bolts to the table. Loosen the
large thumbscrews (A) on each side
of the cabinet, and tilt the cabinet
backwards to the preferred angle.
Tighten the thumbscrews.
Deckhead
Use a small screwdriver to remove
the two upper covers (A). Loosen and
remove the large thumbscrews (B)
and lock washers on each side of the
cabinet. Move the mounting bracket
(C) and fasten it on the top of the
cabinet as shown. Secure the
assembly to the deckhead using four
bolts or screws, and tilt to preferred
angle.