Instruction manual

Simrad PI Remote/Depth

Figure 9 Graphical presentation on PI32

45.9

D1m

S2m

100

(CD012102D)

25.6

This example shows how the trawl door is located at 45.9 m

depth, and that the distance between the trawl doors is 25.6

meters. You can also see how these values have changed during

the last 20 minutes.

The purpose of the depth- and distance markers on the graphical

presentation is to keep an eye on how deep and how far apart the

trawl doors a re situated. The depth sensor in the PI Remote/Depth

measures the distance from the sea surface and down. The PI

Spread sensor communicates with the PI Remote/Depth sensor to

measure the distance between the trawl doors.

1 Identify the sensor you wish to use, and make sure that the

sensor is connected to the PI32 with correct communication

channels and update rates.

2 Ensure that you have a graphical presentation active on your

PI unit.

3 Press the

ENT button to open the Graphic setup menu.

•The

Marker line parameter allows you to switch the

marker lines on or off for sensors S1, S2 and S3.

4 Use the

Marker line parameter to switch the requested

marker line(s) On.

5 Enter the requested values for the marker line

Marker line

thickness

and Marker line delay.

•

Marker line thickness: Use this parameter to control the

thickness (in pixels) of the m arker line(s).

316870/A