Instruction manual

Simrad PI Remote/Depth
1 To reset the unit, set all six sensors to default sensor type
None.
2 Choose the sensor you wish to use for the PI Spread/Depth
sensor; 1 to 6.
3 Define the sensor type (by default None)toDual.
4 Set
Update to the correct update rate.
5 Set
Measure 1 to the chosen sensor type Spread.
6 Set the communication
Channel to its correct value.
7 Set
Measure 2 to the chosen sensor type Depth 300M, Depth
600M or Depth 1000M depending on the depth rating on
your PI Remote/Depth sensor.
8 Set the communication
Channel to its correct value.
9 Press the
ENT button to save the changes and exit.
All sensors are provided with default communication channels
and update rates. Refer to the table in section About sensor
configuration on page 14.
About sensor configuration
All sensors are provided from Simrad with predefined
communication channels and update rates.
Default communication channels and
update rates
See the table below for the initial values for the communication
channels and update rates for the various sensors.
Table 1 Default communication channels and update rates
Sensor Com.channel(s)
Update rate
PI Bottom Contact
6Normal
PI Catch
4Normal
PIDepth(300m)
16 Fast
PIDepth(600m)
12 Fast
PI Depth (1000 m)
10 Fast
PI Height 14 Fast
PI Remote/De pth
Depth 300M: 11
Depth 600M: 15
Depth 1000M: 13
Fast
PI Spread
2Fast
PI Spread/Depth
Depth 300M: 16
Depth 600M: 12
Depth 1000M: 10
Spread: 2
Fast
PI Twin Spread
2 and 7 Fast
14
316870/A