Instruction manual

Configuration
We recommend that you use the form at the beginning of the
PI32 Operator manual to write down the sensors you have and
their respective communication channels and update rates.
Figure 5 PI Remote/Depth configuration example, PI32
2
11
FAST
FAST
Sensor 1:
SINGLE - Update:
SINGLE Update:-
NONE - Update:
Measure 1:
Measure 2:
Sensor 2:
Sensor 3:
Sensor setup:
(CD012103A04)
SPREAD - Channel:
DEPTH 300M - Channel:
This example shows how the PI32 is set up to receive information
from a PI Spread sensor and a PI Remote/Depth sensor. Standard
communication channels and update rates are used.
To access the
Sensor Setup menu:
1 Press the
MENU button to open the main menu.
2 On the
Setup menu, select Sensor setup.
3 Press the
ENT button to allow for changes, and then the
same button one more time to accept the warning.
• You must now use the circular navigation button to
move the cursor between the parameters, and the + and
- buttons to select values.
To set up the depth readings from the PI Remote/Depth sensor:
1 Choose an available sensor; 1, 2 or 3.
2 Define the sensor type (by default None)toSingle.
3 Set
Update to the correct update rate.
4 Set
Measure to the chosen sensor type Depth 300M, Depth
600M or Depth 1000M depending on the depth rating on
your PI Remote/Depth sensor.
5 Set the communication
Channel to its correct value.
All sensors are provided with default communication channels
and update rates. Refer to the table in section About sensor
configuration on page 14.
Configuration of the PI44 and PI54
This procedure explains how to set up the PI44 and PI54 catch
monitoring systems to access the information provided by the PI
Remote/Depth sensor. For more detailed information about the
settings and parameters, refer to the relevant Operator manuals.
We recommend that you use the form at the beginning of the PI44
or PI54 Operator manual to write down the sensors you have and
their respective communication channels and update rates.
316870/A
11