Specifications

Simrad PI32
48
857-164636 / Rev.A
How to set up the sensors
The very first time you switch on the PI32, you will need to set
up the sensor configuration. This will also be required if you
perform a “master reset” on the PI32, and then reload the
manufacturer’s default settings.
Observe the following procedure to establish the most common
values. For more detailed information about the settings, refer to
the References chapter.
Note: In order to establish the sensor configuration, you need to know
what kind of sensors you have, which channels they
communicate on, and how often they communicate. This
information is required before you start the configuration on the
PI32.
Note: Do not attempt to set up the sensors unless this is absolutely
necessary.
We strongly suggest that you use the form s in the front of this
manual to write down the sensor you have with information
about their update rates and communication channels.
1 Press the MENU button to open the main menu.
2 Open the Setup menu, and select Sensor setup.
3 Press the ENT button to enable modification. Observe the
warning, and press the ENT buttontoproceed.
- In the following, you must use the Selector pad to
navigate through the parameters, and the + and -
buttons to select values.
- Each of the three sensors are initially set to None and
Normal, and the communication channels are not
defined.
4 For Sensor 1:
a Set type (currently None)toSingle.
b Set Update to the current update rate of the chosen
sensor (Slow, Normal or Fast)
c Set Measure to the type of sensor.
d Select transmission Channel (currently NO), and use
the + and - buttons to select desired channel.
5 Repeat for Sensor 2 and Sensor 3.
6 Press the ENT button to save the configuration and exit.