Specifications

Simrad PI32
184
857-164636 / Rev.A
PI CONFIGURATOR
Purpose
The purpose of the PI Configurator utility is to be able to
configure sensors so that they can operate on different
communication channels. Several PI equipped vessels may then
operate simultaneously in the same area without interference.
The utility also allows you to change the update rate on each
sensor. This is the time elapsed between each data transmission
from the sensor to the host PI system.
This document describes software version 3.40.
Introduction
→ Basic information, page 185
→ About sensor configuration, page 187
→ Main dialogue description, page 189
Procedures
→ How to perform software installation, page 192
→ How to interface the sensor, page 193
→ How to perform basic sensor configuration, page 194
→ How to set up a Twin Spread system, page 195
→ How to upload factory settings, page 197
Reference information
→ References, page 198
Maintenance
→ Programming modes, page 220
→ Making a programming cable, page 221
→ Troubleshooting, page 222
Sensor test procedures
→ Sensor test procedures, page 223