Specifications

Simrad PI32
136
857-164636 / Rev.A
System configuration
Sensor configuration: The sensor must be configured with a
unique sensor number. Select channel number according to the
sensor’s configuration. Write down the configuration for future
reference.
Status & Receiver: The Interference filter must be switched on.
Set it to level 9 if you have noise problems from other
hydroacoustic sources. Note t hat with the filter on, it will
influence the signal spectrum shown in the St atus display.
Sensor filter: Switch this f ilter to Light. Set it to Heavy only if
you experience excessive noise. Position Off will provide raw
data and fastest possible response.