Installation manual

SimradPI50
Note
Thisisa“dual”sensor .ItwillseizetwocommunicationchannelsonthePI50.
1ClicktheSetupiconundertheMainmenutoopentheSetupmenu.
→Setupmenuonpage112
2ClicktheSelectSensorsbuttontoopentheSelectSensorsdialog.
3ObservetheAvailableSensorseldontheupperleftsideofthedialog.Itlistsall
thesensortypessupportedbythePI50.
4ClickonceontheSpread/Depthsensorinthelist,thenclickthe[►]buttontocopy
thesensortotheSelectedSensorslist.
5Observethatanerrormessageappearsifyoutrytoaddtoomanysensorstothe
SelectedSensorseld.
ThePI50canhandlemaximumsixsensors.Rememberthatdualsensorseachseize
twocommunicationchannels.
6IntheSelectedSensorseld,clickonceonasensortoselectit.
7Clickoneofthe[▲]or[▼]buttonstomovethesensorupordownonthelistin
theSelectedSensorseld.
Theorderinthislistalsocontrolstheorderinwhichthesensorsarepresentedinthe
SensorCongurationeld,aswellastheverticalorderofthesensorviewrectangles
inthePI50displaypresentation.
→Howtocontroltheorderofthesensorviewsonpage71
8IntheSensorCongurationeld,choose:
aLabelID
bLabelName
cUpdateRateforeachofthetwosensors
dSensorValueNameforeachofthetwosensors
ThesenamesyouenterareshownintheSensorviews.
→PISpread/Depthsensorviewonpage45
eChannelNumber
fOffsetforthedepthsensor
Theoffsetforthesensoriscalculatedautomaticallybymeansofthecalibration
procedure.Ifyoualreadyknowtheoffsetvalue,youcanenteritdirectly.
→Howtocalibratethedepthsensorsonpage92
gOffsetforthespreadsensor
88
328457/A