Specifications

Simrad NX40/45 Installation and Operation Manual68
Notes:
The range of engine idle RPM adjustable available for •
both RPM and speed mode depends on engine type.
Generally, it is between 600 and 1000 RPM.
In speed troll control, the boat might not reach the •
desired speed if the maximum RPM available for troll
control is too low or if conditions are bad.
Troll control is not available on some displays or •
engine.
17-3-4 Trim indicator
When you adjust the engine trim, a trim popup window
shows the new trim angle. To see this window or not:
Set Trim popup to• On or Off
The Trim popup window will automatically disappear
after two seconds.
17-3-5 Engine/helm fault alarms
There is a wide variety of SmartCraft engine and •
helm fault alarms. These alarms operate just like
other alarms - when the alarm sounds, you can
mute it. Other features include:
If a fault occurs then the engine will send out •
information to your display, providing you with
information about the fault.
For engine models 2007+, you will also receive •
further details, and a recommended course of
action.
For Cummins Mercruiser Diesel (CMD) engine •
models, you will also receive a fault code, which you
can report to your mercury dealer.
Notes:
For help when a SmartCraft alarm occurs, contact •
your Mercury dealer.
SmartCraft alarms are always on. The engine type •
automatically sets the alarm values.
If required, you can display a list of active faults and •
fault history.
To access the engine fault list:
From the DISPLAY menu, select 1. More…
Choose 2. Engine Faults at bottom of page.
Below is an example of the engine fault list.