Specifications

Simrad NX40/45 Installation and Operation Manual60
User card window15
A user card is an optional plug-in card that can store
data les. There are three types of les: waypoints,
routes or a track.
To go to the user card window
> More > User card
The user card window has:
File list
A list of the les on any user card in the unit.
To scroll up or down a page at a time
Waypoints, Routes
The number of waypoints and routes currently in the
unit.
Track 1 to Track 10
The number of points in tracks 1 to 10 currently in the
unit.
Note:
To save data onto the user card, use the Save •
command (see below).
Data stored on the user card and shown on the le •
list is not available to be used by the unit until loaded
into the unit with the LOAD command (see below).
Saving data to the user card
> Save > Waypts or Routes or Tracks
This saves all the unit’s waypoints, all the unit’s routes or
one of the unit’s tracks to one le on the user card. For
Tracks, select the track number to save.
The new le is created. Change the name if required.
The new le appears in the le list.
Loading data from the user card to the unit
This loads one le from the user card to the unit:
A waypoints le: The new waypoints are added to •
any existing waypoints in the unit. If a new waypoint
has the same name as an existing waypoint but has
CAUTION
!
!
CAUTION
DANGER
WARNING
Before using a user card,
remove any chart card
and plug the user card in.
When you have nished
with the user card,
remove the user card and
replace the chart card.