Installation guide

| 13
NSS | Addendum for RTM-2, RTM-2.5 and RTM-3
EN
GoFree™ Wireless
With a WIFI-1 unit connected to an NSS with RTM-2.5 software, you can use a wireless
device to remotely control the NSS. The NSS is controlled from the wireless device by Apps
downloaded from their relevant Application store.
¼ Note: In this document we have used the term wireless devices, and graphics from iPad
and App Store are used as examples. The wireless functionality is however, provided for other
vendors’ tablets or smartphones, and those can be used for controlling the NSS when relevant
Apps are available.
¼ Note: For security reasons Autopilot and CZone control are currently not supported for control
from a wireless device.
Installation and wiring for the WIFI-1 unit are described in the separate WIFI-1 Installation
Guide.
Setting the NSS name
The name of the NSS can be set by the user. The entered name will be broadcasted on NMEA
2000 and IP based networks.
Choose a unique name for each NSS to allow you to identify each unit on the Simrad GoFree
Controller & Viewer App.
Setting up the WIFI-1
1. Connect the WIFI-1 unit to the NSS with the Ethernet cable supplied with the WIFI-1 unit
- The WIFI-1 access point will now be listed in the NSS menu
- The Network name and Network key are the same as found on the sticker on the WIFI-
1 unit
2. Change the Network name and Network key if required